Rachel Burgon
Forum Replies Created
-
AuthorPosts
-
Hi Alex, thanks I’ve followed your suggestions and think I have installed it ok. The question now is when I go to the Geodirectory dashboard it says “run setup” wizard. I think I do need to do this as currently I can’t see how I add the listings/modify the search parameters etc that i used to do through the dashboard/interface.
Can you confirm that I should now run set up wizard? I’m just super worried that I’m going to overwrite all my existing hard work….
Thanks
October 14, 2018 at 11:36 am in reply to: GD Pages have disappeared after installing a holding page #449630That’s perfect thank you so much 🙂
October 14, 2018 at 9:13 am in reply to: GD Pages have disappeared after installing a holding page #449616This reply has been marked as private.Hi Paolo – thanks for getting back I’ve actually switched themes now and working better 🙂
I’ve found that so far Magazine plus seems to be doing a good job 🙂 (touch wood)
Sure I can do that but just to clarify what the question is:
On GD Home there is a “Top Section” where I have placed the advanced search tool.
However I would like the homepage to actually be the blog post page rather than a static page but if I set it as the blog post page then the option of a “Top Section” doesn’t seem to be available.
So is it possible to have the blog post page as the home page and maintain a “Top Section” in which I can place widgets such as the search tool?
Cheers
April 16, 2018 at 4:08 pm in reply to: Filtered search results do not show all the correct results #426824I have realised it’s because you need to tag each entry to a category before it will allow an entry to be searched for and filtered!
April 15, 2018 at 11:04 am in reply to: Filtered search results do not show all the correct results #426688This reply has been marked as private.Update – think i Know now – place settings – advance search then change to ‘check’
-
AuthorPosts